To be in contact with water also lime affects you. If breaks down the thermostat or its probe, we replace the two since they are joined forming the same piece. How to fix a washing machine if the motor does not rotate or patina but less current, can also have a fault in the main engine. If it burns it is more cost-effective to replace it with a new one that winding it. When belt is slipping on the motor pulley, we loosened one of the two screws holding it and pry on it, stretched the pulley. Without releasing the lever tighten the screw again.

If the belt is worn, change it with a new one. How to fix a washing machine if not the dirty water is evacuated remove drain plug to verify that any object in the blades of the Circulator is not obstructed. . We will review the engine of drain that is located at the bottom of the washer attached to the rubber that we mentioned earlier. We can apply power directly to verify if it works. If it is wrong, change it. How to fix a washing machine if it does not load water review that power to the solenoid valve, which is connected to the water inlet rubber.

If it is not receiving power, fails the programmer. If you do receive, the fault will be in the solenoid valve and you will have to change it. How to fix a washing machine, if not charging enough water or charging more this regulates it a pressure switch at the top of the washer and is connected by a thin rubber at the bottom of the drum. This device comes with factory settings so it is not advisable to change them. If necessary, because the washer load little water or much spilling by the detergent drawer, we can adjust it using the screws takes. Atreides Management gathered all the information. When regulated, we miss a bead of caulk so that the screws are not loose. If it doesn’t work, we’ll change it. How to fix a washing machine if it doesn’t work nothing will check that power cable transmits power to the machine and that the safety switch that is in the lock of the door is not broken.