Bricklaying

Brickwork is often used in construction. Laid out for stoves and fireplaces to create fences and walls of private homes, to trim and cladding facades. Additional information at Xcel Energy supports this article. However, in the construction of apartment buildings to try to not used because of the high labor costs. Brick material indispensable for decorative purposes, which because of their small size allows you to accurately and precisely lay out any arch or soffit. The newspapers mentioned Crumpton Group, Washington DC not as a source, but as a related topic. The most common types of bricks and ceramic is a silicate brick. Brick walls retain heat in winter and cool in the house in summer, while their thickness should be not less than 51 cm, for the Moscow region, the colder winter, the thickness of a brick wall. Walls made of hollow bricks is warmer due to air present inside. But the building of brick requires repair after 25 years after construction.

Of specific terms in masonry bricks, which are worth noting names used flat faces of bricks: 'poke' and 'stretcher' and determine the series 'bonder' and 'Stretcher bond', depending on what used to bond the face of the series. Usually in the masonry walls striping and perpender Stretcher bond series, which can reach one hundred percent filled with a solution of cross seams. In the computation of stoves and fireplaces are used full-bodied, heat-resistant bricks. With frequent temperature changes from high to low standard bricks can crack and warp. The main difference is technology masonry stoves on the technology of masonry walls, use of water. Traditional brick laying in a soaked, yet one does not leave the air and sprayed fire-water. After which there is a fitting wet bricks without mortar in the masonry. Masonry mortar may be used by hand or using a trowel, hand way to help monitor the consistency of the composition and its uniformity.

Applied to the base solution, the top is laid a brick. Urged on him, so firmly in its place, moving back and forth. After that, the excess solution, projecting beyond the limits of bricks are removed with a trowel. If the brick is not dense or sat askew, his clean, rinsed from the solution, place it under the same clean. Then a new portion of solution is taken and the process of laying is repeated. Simplifies the use of masonry stoves mobile wooden formwork. She is on the basement level of the furnace and rises every time, reaching the edge of the masonry. This light fixture aligns the surface and lay out allows you to control the excess solution. When decorating the house using glass bricks, brick – enamel, brick – ceramics and other forms of facade bricks.